As the country has increasingly strict requirements for food quality and safety, food processing companies dare not ignore this. Among them, the opening and sealing of bottles have become indispensable packaging links, and it has also become a trend to strengthen food sealing packaging. In this regard, the continuous innovation and progress of filling and capping machines provide strong equipment support for bottled food packaging.
When people buy the filling and capping machine, they look to the big manufacturers and the quality of the products. The after-sales service of the filling and capping machine is also important. Let me introduce the common faults and repair methods of filling and capping machines:
1. Automatic start and stop failure The possible cause is the drift of the micro switch or photoelectric switch. Remedy: Adjust the working position of the micro switch or photoelectric switch, or exchange for a new switch
2. Pneumatic transient overcurrent There are two possible causes, one is the motor winding and the shell are short-circuited, the other is the motor wiring and the grounding wire is short-circuited.
3. Overcurrent during acceleration. Possible reasons: 1. The acceleration time setting is too short 2. The motor capacity exceeds the inverter capacity. Remedy 1. Extend the set time appropriately 2. Do not change the motor capacity at will
4. The voltage is too high during operation. The possible cause is that the power supply voltage has changed too much. The troubleshooting method is to add a reactor or reduce the power supply voltage appropriately.
5. The voltage is too low during operation. It may be that the power supply voltage is too low or there are often large-capacity equipment pneumatics on the same line. Elimination method 1. Improve the quality of the power supply 2. Use a separate power cord
6. The motor is overloaded. Possible reasons: 1. The load is too large. 2. Whether there is a jam on the machine. 3. The setting is improper. Solution 1. Whether the motor capacity is suitable. 2. Whether the machine is normal. 3. The setting may be too small.
