Nowadays, the industrial market is selling its products crazily and wants to take a share in its own industry. However, it is not easy to get a foothold in the market. It needs the support of users. Naturally, satisfying users has become the most urgent problem for every enterprise. It's very simple to satisfy users, that is to make your products speak. In addition to the most important quality of products, we should also pay attention to its after-sales service. Next, I will introduce the maintenance knowledge about the ribbon printer for the maintenance personnel.
In the color belt coding machine, the driving belt of the driving wheel of the color belt will be broken or worn due to the friction drive of the character chain or the use time of the driving belt is too long. The troubleshooting method is to adjust the position of the character chain so that it no longer rubs the driving belt; the broken and damaged ones need to be updated. Usually, the edge of the ribbon is easy to get tangled with the ribbon wheel after being stripped and fluffed, which causes the ribbon wheel to get stuck, and the ribbon cannot be retracted normally. The troubleshooting method is to open the cover, open the ribbon swivel arm and the hammer row interlock handle, pull the ribbon back slightly at the belt feeding end of the ribbon box, then close the ribbon swivel arm and the hammer row interlock handle, and turn on the power supply. After self inspection, the ribbon will be It's put back into the ribbon box. Sometimes the tension of the color belt is too large, and the color belt is broken by pulling the suture or breaking the color belt with a hammer. In this case, the broken part can be cut off, repaired or directly renewed. When the customer's color belt coding machine fails to repair, if you have a friendly attitude and repair their machine well, then I believe that your products will add value in their hearts.
There are also some problems that should be paid attention to in the daily maintenance of the color belt coding machine. With two bubbles of better quality printing ink, clip a ribbon on the front of the ribbon box, gently rotate the ribbon axis, add some ink to the ribbon that has been used for a period of time, then open the ribbon box and allow the ink ribbon to cool down and use it. First, try a few pages of informal manuscripts to make the ink evenly distributed, and then print the official draft. Two pieces of foam are fixed with transparent adhesive tape, and the ribbon is sandwiched between two bubbles. At the same time, the foam is filled with some good quality printing ink, which can keep the ribbon moist, prolong the use time of the ribbon, and save the investment of the enterprise.
