During the operation of the capping machine, the cap buckle is often bad or slanted. The general adjustments and precautions are as follows:
1. First drop the lid and adjust
Ensure that the angle between the cap drop track and the bottle mouth is 50°. The best height of the cap drop track is that the bottle cap is hung at 2∖3 of the bottle mouth so that the medicine bottle can pass smoothly without jamming.
2. Screw cap adjustment
①Adjust the height of the rack to make the bottle height fit the pre-pressing plate. The pre-pressing plate just sticks to the upper surface of the bottle cap, and the bottle cap is parallel to the bottle mouth.
②Adjust the spacing of the bottle clamping belt so that the bottle body has a certain clamping force in the timing belt. It is not easy to be too tight and the bottle may be deformed and affect the labeling. The bottle body shall not slip when the cap is screwed.
③Adjust the pressure plate so that the distance between the bottle cap and the bottle cap is about 1~2mm, and the bottle body can pass between the plates smoothly without falling
④Adjust the spacing of capping wheels, and adjust the spacing of the 3 sets of capping wheels in turn. The spacing is slightly smaller than that of the bottle cap. The gap of the first group is not easy to be too small, and the bottle is easy to fall.
3. Control panel data adjustment
The speed of capping, screwing and clamping the bottle is adjusted according to experience to ensure that the bottle cap is tightened and the bottle does not fall.
