What should I do if the position of the automatic labeling machine is not correct when it is working? With the continuous upgrading of the labeling machine technology, it has been widely used in every field, and the problem of incorrect labeling parts is often encountered in the work. How do you solve it? Let's take a look below.
The reason that the labeling position of the automatic labeling machine is incorrect is likely to be caused by the following conditions:
1. The clamping device may not be pressed tightly, causing the label tape to loosen, and the color label sensor inspection is prohibited. Press the label to solve it.
2. It is very likely that the traction belt mechanism may be off-track and may not be pressed tightly, resulting in failure to remove the bottom paper smoothly. Tighten the traction belt to deal with it. If it is too tight, the label will be distorted. It is better to drive the bottom paper normally. (Generally, if the bottom paper pulled out is wrinkled, it should be pressed too tightly)
3. The appearance of the posted object may be different, and the precise location may be different. Manipulate product quality.
4. The object to be labeled should be placed parallel to the bottom position of the label (note whether the product moves during the entire process of labeling, and the left support frame can be appropriately developed than the right side)
5. During the labeling process, the object to be pasted should be turned smoothly (note that the stripping board should not be encountered). When the object is too light, learn to put down the covering example and press the object
6. In the case of double standards, the labeling machine produces a label (1) After a label is produced, the product workpiece is turned over all the time, because the second label is not set, and the equipment is waiting for the second label The case of labeling data signals. (2) After a label is issued, the product workpiece is interrupted. It is due to the data signal intrusion of the measuring mark sensor (set the color mark sensor again), perhaps due to abnormal operation at the time (after a few clicks to activate the light 2, then a few more clicks to activate the light 1.
The above is the problem of what to do when the automatic labeling machine is working incorrectly. The next time you encounter the same problem in your work, you can quickly solve it yourself.
