At present, the pillow packing machine is a packing machine with relatively strong packing capacity. The pillow packaging machine can not only complete the packaging operation efficiently and quickly, but also improve the adaptability to various irregular products, especially some hardware accessories, toys, daily necessities and other products.
Common fault detection of pillow packaging machine:
1. The color of the film color mark is too light, the film drive is deviated, or the color mark tracking is not performed when the color mark is moved at the cutting position, please refer to the following maintenance instructions. Manually adjust the sensitivity in the packaging machine. In the man-machine dialogue interface, switch the tracking mode to "Tracking Cut".
2. If the solid state circuit breaker burns out, the temperature controller is damaged, and the heat resistance is damaged, the thermometer will lose control of the temperature. Repair methods are galvanic replacement, temperature controller replacement and heater replacement.
3. If the knife plate is too high or too low, the packing speed is too fast or the push rod is out of sync with the cutter, the cutter will cut the product. The overhaul is to reduce the packing rate and adjust the height of the end seals to form a seal. The center of the knife is in the middle of the product height
4. If the temperature is too high, the speed is slow and the surface layer of the coating has poor heat resistance, the repair method for leaving scorch marks on the seal is to adjust the speed to reduce the temperature and change the material of the film.
5. The speed is too fast, and the heat sealability of the inner layer of the film is poor. If the temperature is too low, the seal may leak or become unstable. The maintenance method is to slow down, increase the temperature and replace the membrane material.
6. The air pressure is wrong, the cylinder swing rod falls off, the heating temperature is low, and the heat seal is not parallel. The maintenance method is to adjust the flatness and temperature. And adjust the air pressure to make it harder.
