In order to standardize the operation process of this position, improve production efficiency, and ensure the steady improvement of product quality, maintain the normal operation of equipment, the following regulations are formulated:
1. Sanitation:
1. Clean the hygiene in the work area in time before going to work every day, including window sills, loading hoppers, material tables, molding machines and any parts of the equipment, so that the ground is clean, the equipment is dust-free and bright, and there is no leftover material and impurities on the equipment table. Clean and sanitary below and around;
2. When changing raw materials, clean up the remaining medicines in time, and do not mix them. Products with the same variety and different specifications in the production package may not be cleaned;
3. The operator should maintain good personal hygiene, wear a work cap and work clothes during work, and no makeup, such as jewelry, dyeing nails, etc.;
2. In terms of production quality:
1. When receiving raw materials, carefully check the quality of the raw materials (whether there are impurities, whether they are wet, etc.), refuse to use the raw materials that do not meet the packaging requirements, and report to the monitor in time. If the raw materials are not inspected and the packaging is produced, the quality problem The operator is responsible.
2. When the product is produced, strictly follow the packaging requirements of the quality department, and there should be no overweight or ultralight products; it is necessary to carefully check the internal quality, appearance and other aspects of the products produced, whether there are obvious defects, and problems should occur. Stop the machine in time. The person responsible for a small amount of problem products shall bear all the losses, causing mass product quality problems, the losses shall be jointly borne by the operator, the workshop quality inspector, the person in charge of the workshop, and the person in charge of the quality department according to the degree of responsibility, and in accordance with the company's quality management regulations Fine.
3. Equipment operation and maintenance aspects
1. The operator is responsible for the production operation of the two fully automatic machines, and keeps a record of the daily equipment operation;
2. Take care of every part of the machine and equipment, especially the computer-operated components, and do a careful and careful debugging every day;
3. Operate strictly in accordance with the equipment manual, and do not operate in violation of regulations or intentionally cause equipment failure;
4. Do not allow personnel unrelated to production to operate the equipment, and do a good job in the maintenance of the equipment. If there are operational problems that cannot be solved, they must report to the company's maintenance personnel and contact the maintenance personnel in time.
5. When debugging the equipment, the workshop should arrange personnel to cooperate with the operator to shorten the debugging time.
