Today, the vacuum packaging machine manufacturer-Jiaozuo Fonfar Vacuum Packaging Machinery Co., Ltd. takes you to understand the solution to the displacement problem of the vacuum packaging machine.
There are two types of commonly used single-chamber and double-chamber. The single-chamber is a flat plate type. There are two sets of support frames on the back of the upper and lower vacuum systems. There is a long shaft with a double torsion spring in the middle, which is balanced by the double torsion spring. The interaction force opens the viewing angle of 45-75 degrees.
The double chamber is reciprocating. The lower vacuum system is divided into two upper and lower working rooms. The upper vacuum system is offset up and down by the support points of the four crankshafts. The four crankshafts are fixed on the two long shafts. There are tension spring forks on the long shafts. , The lower side of the two tension springs is fixed on the sound card frame, and the upper end is fixed on the tension spring fork, which has the effect of equalizing the actual operating force. The two long shafts are accurately positioned by the two sets of seated bearings. Four crankshafts The upper end is also inlaid with miniature bearings, so the up and down shift is very light and easy. The vacuum pump starts with a slight working pressure and can be fully automatically opened after the air return is completed.
The support points are offset from the four connecting rods of the upper vacuum system. The front and rear, left, and right sides of each long axis must be maintained in parallel. The upper and lower crankshafts should also be relatively parallel to ensure that the upper vacuum system is in all parts of the upper and lower parts. Keep parallel planes with the lower vacuum system. Otherwise, the upper and lower vacuum systems cannot maintain parallel planes, and the actual operating pressure will increase significantly. When it is more serious, it is impossible to create a vacuum pump normally.
