The pellet packaging machine is suitable for packaging some free-flowing pellet products such as traditional Chinese medicine, pesticides, feed, salt, soup, seeds, etc. If the equipment is used for a long time, some minor problems will inevitably occur. At this time, the maintenance of the equipment is extremely important.
Maintenance of pellet packaging machine:
Care instructions:
1. Check the parts regularly, once a month, check whether the worm gear, worm, bolts on the lubricating block, bearings and other movable parts are flexible and worn. If any defects are found, they should be repaired in time and should not be used reluctantly.
2. The machine should be used in a dry and clean room, and should not be used in places where the atmosphere contains acids and other gases that are corrosive to the body.
3. After the machine is used or stopped, the rotating drum should be taken out to clean and brush the remaining powder in the hopper, and then install it, ready for the next use.
4. When the roller moves back and forth during work, please adjust the M10 screw on the front bearing to the proper position. If the gear shaft moves, please adjust the M10 screw on the back of the bearing frame to the proper position, adjust the gap so that the bearing does not make a noise, turn the pulley by hand, and the tension is appropriate. Too tight or too loose can damage the machine. .
5. If the machine is out of service for a long time, it is necessary to wipe and clean the whole body of the machine, and coat the smooth surface of the machine with anti-rust oil and cover it with a cloth canopy.
Machine parts lubrication:
1. The box part of the machine is equipped with an oil meter. You should add all the oil once before starting up, and you can add it in the middle according to the temperature rise and operating conditions of each bearing.
2. The worm gear box needs to store oil for a long time. The oil level is high enough that the worm gear invades the oil. If it is used frequently, the oil must be replaced every three months. There is an oil plug at the bottom for draining oil.
3. When refueling the machine, don't let the oil spill out of the cup, let alone flow around the machine and on the ground. Because oil easily pollutes materials and affects product quality.
No matter what kind of equipment the machine has been used for a long time, some minor problems will inevitably occur. As long as everyone pays a little attention and regularly maintains the equipment, the service life of the equipment can be increased. I hope everyone can take good care of their work partners.
