Common problems of plastic tube filling and sealing machine are as follows:
1. The time when phenomenon 1 appears on the left is generally caused by excessive temperature. At this time, check whether the actual temperature is the temperature required for the normal operation of the standard hose. The actual temperature on the temperature indicator should be relatively stable at the set temperature (the normal error range is between 1°C and 3°C).
2. There is an ear on one side: first check whether the heating head is correctly placed in the heating head socket; then check the verticality of the heating head and the hose below. Another possible cause of the phenomenon of one ear is that the two tails are caught.
3. The tail seal is cracked from the middle of the hose. This phenomenon is caused by the inability to use the heating head. Please replace with a larger heating head. The standard for judging the size of the heating head is to pierce the heating head into the hose and then pull it out. When pulling it out, you feel a slight suction.
4. "Bag under the eyes" under the end seal explosion-proof line: This situation is manifested by the wrong height of the heater head exhaust hole, which can be adjusted according to the following methods.
5. The center of the hose tail is sunken: This problem is generally caused by the wrong size of the tube cup.
